Citata:
Pradžioje rašė bitch
Įmetu instrukciją. 1a ir 1b diskas bus įrašytas į dvd-dual layer, o dvd 2 į paprastą dvd.
This update takes a couple hours, put the car on a charger or make a long drive, and sometimes click on the knob to let it get out if idle if the screen goes black (This only happens if the car is on a charger and engine is turned off)
insert DVD 1a, up to about 3% are achieved.
You will see a message that it can not be updated, and it is required by the DVD 1.
Insert DVD 1b, the update is now prefixed by about 3% to 58%.
Then again, the DVD insert 1a, now is updated from about 58% to 92%.
Finally, the DVD 2 Insert and update their approximately 92% to 100%.
|
Pas W212 spėju ta pati procedūra?
|